EU Declaration of Incorporation (DOI)#

According to the European Commission’s Machinery Directive 2006/42/EC, Annex II, Section 1B

The manufacturer
Mecademic Inc.
1300 Saint-Patrick Street
Montreal QC H3K 1A4
Canada
Authorized representative
Dennis Huber
Ginsterweg 6
78087 Mönchweiler
Germany

hereby declares that the product described below

Product designation:
Type:
Firmware:
Date of manufacture:
Extra-small six-axis industrial robot Meca500
Meca500-R4
10.1 and newer
October 2024 onward

meets the applicable essential safety requirements of the Machinery Directive 2006/42/EC (1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.4.3, 1.2.6, 1.3.2, 1.3.4, 1.5.1, 1.5.2, 1.5.5, 1.5.6, 1.5.8, 1.7.3, 1.7.4) and was designed based on the norms ISO 10218-1:2011, IEC 60204-1:2016, ISO 13849-1:2015, ISO 13849-2:2012, ISO 13850:2015. Deviations from these norms exist. These are listed in the User Manual of the robot.

Additionally the manufacturer declares the product in conformity with the following directives and harmonized standards:

  • 2014/30/EU Electromagnetic Compatibility Directive (EMC)

  • 2011/65/EU Restriction of the use of certain hazardous substances (RoHS)

  • 2011/35/EU Low-voltage Directive

  • EN IEC 61326-1:2021

  • EN IEC 61000-3-2 (2019) A1 (2021), EN IEC 61000-3-3 (2013) A1 (2019) A2 (2021), EN IEC 61000-4-2 (2008), EN IEC 61000-4-3 (2020), EN IEC 61000-4-4 (2012), EN IEC 61000-4-5 (2014) A1 (2017), EN IEC 61000-4-6 (2013), IEC 61000-4-8 (2009)

The manufacturer agrees to forward on demand the relevant technical documentation, compiled according to Directive 2006/42/EC, Annex VII, Part B, to state authorities.

We declare that the partly completed machinery must not be put into service until the final machinery into which it is to be incorporated has been declared in conformity with the provisions of the Machinery Directive, where appropriate.


Montreal, QC, Canada
October, 2024
sig_eric
Éric Boutet, Eng.
Vice president of R&D