1. Introduction

The MPM500 is a custom pneumatic module developed by Mecademic, specifically for the Meca500 robot arm. The module essentially consists of two 3/2 NC valves and is easy to install, connect and dismount. The module allows easy integration between the Meca500 and a large variety of single- or double-action pneumatic grippers, suction cups, tool changers, and other pneumatic devices.

Note

Familiarity with the Meca500 robot and its user manual is required prior to installing and using the pneumatic module.

Warning

Improper installation of the pneumatic module could seriously damage the Meca500 and the module itself. This module should therefore be used only by technical personnel who are familiar with the Meca500.

1.1. Inside the box

The MPM500 module is supplied either separately or with the Meca500. In both cases, the module, shown in Figure 1, is delivered as a standard kit in an anti-static bag, the content of which is:

• 1 MPM500 module with a MGC-AA25 25 mm communication cable with a 90° connector;

• 3 M5X0.8 pneumatic barb fittings for tubes of 1/16 inch internal diameter (installed);

• 1 M5X0.8 pneumatic silencer (installed).

Figure 1 MPM500 module with barb fittings and silencer installed

Note

Note that we also supply the MPM500 as a kit with a pneumatic gripper from Schunk, either MPG-plus 25 or MPZ 30, the appropriate adapter plates and 4-mm tubing.